"Slow" is a key word in the driving process of automatic feeding mixer. Be sure to turn slowly. The mixer truck has a high center of gravity and is easy to overturn! Slow down and downshift before entering the corner, and try not to slam on the brake when crossing the corner. Through the rearview mirror at any time, pay attention to observe whether the can is rotating and slow down as much as possible. Because the speed is too high, the mixer truck is easy to swing. When fully loaded, stop the tank first when walking to the section with large inclination angle. The center of gravity of the mixer truck is high, and stopping the rotation of the tank is conducive to ensuring the stability of the vehicle.
On bad roads, use the right low gear to overtake. In case of uneven roads, potholes and other situations, use the appropriate low-speed gear to ensure that the car has explosive power at any time. Boards and sharp stones should be avoided as far as possible!
When going uphill, it is recommended to downshift in advance. If the mixer truck is full, pay attention to starting gently and pay more attention when going uphill. You shouldn't downshift at will, so you can downshift in advance. Do not slide heavy vehicles into neutral when going downhill. Get used to testing the brakes before driving for a long time or going downhill. Do not slide downhill when heavy vehicles are in neutral. When turning downhill, slow down in advance, then downshift and then slow down. Good braking effect with gear.
Pay attention to the height limit. Pay special attention to the complex construction conditions, such as trees, wires, etc. In addition, pay more attention to some matters when the mixer truck enters the construction site, such as:
When entering the construction site, try to walk in the middle. The site road is simple and the subgrade is soft. Now the cement mixer has reached more than 10 square meters. If they drive close to the roadside, the road is easy to be crushed and collapsed, resulting in vehicle rollover.
Get off in advance and check the reversing line. Many mixers work at night. After arriving at the construction site, you'd better get off the bus and take a flashlight to check the reversing route. If there are obstacles, potholes or soft places, remember to clean the steel nails in time.
Slow down when reversing. Don't always stick your head out of the window. Take good care of the rear-view mirrors on both sides. If you're really not sure, please stop and have a look before pouring the wine. Many roads just paved by excavators are relatively soft, and the mixer truck is easy to sink in. Start in first gear, drive slowly and evenly, and reverse the route as straight as possible. If you want to crash repeatedly, don't kill the steering wheel or use too much force.
In addition, do not let the automatic feeding mixer break down on the road, otherwise it will be very troublesome to have a stuffy tank. Before ignition, check engine oil, antifreeze, lubricating oil and cooling water. If you find any deficiencies, add them again. After starting, let the jar rotate at a low speed and check the surrounding tire pressure to see if there is a leaking tire.
Then use a screwdriver to dig out the stone in the tire seam and check whether there are nails in the tire. Check the lamp again, especially the waist lamp, and ensure that it can shine on the edge of the tire. The construction site will often stack reinforcement, etc., and the side wall is very weak and vulnerable. Clean both sides of the rearview mirror and window glass with a rag. The road conditions on the construction site are complex and the light is not good. It is necessary to ensure the line of sight!
Therefore, before operating the mixer, you should check carefully and find the fault in time. Personnel safety is the top priority. Don't take chances. For more information, you can visit tjjh.net Com follow consultation!